Peugeot 308 Key Fob Replacement

Peugeot's 308 might seem a bit old but it's attractive. It's not the most luxurious vehicle in its class, but it is a relaxing and civilised drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following suggestions will assist whether the issue is intermittent, or constant.

Water Damage

When you accidentally leave your key fob in a puddle or get it wet while swimming, kayaking, canoeing, rafting or canyoning, it's probably to be damaged by water. The best method to prevent this from happening is to keep it in a dry bag whenever you're going outdoors or doing things where the fob might be exposed to excessive amounts of water.

It's also essential to make sure the fob has completely dried out before you open the fob and then use it. If you detect any odors emanating from the fob (such as industrial liquid or windshield washer fluid) it is a indication that it's been submerged.

A circuit that is wet can cause the battery's energy to drain or even explode. If you are able to get your keyfob 308 out of the water and turn it upside up and shake as much water as possible before opening the casing. Take the battery out, and then wipe the circuit board down using a cotton swab that is dipped in 90 percent alcohol.

Other reasons that your Peugeot 308 remote entry keyless system might not work include a dead battery in the coin-cell or receiver module issues, signal interference or a faulty chip. If none of these are the issue, try resetting the system by removing the battery that is 12 volts for approximately 15 minutes.

Dead Coin Battery

Peugeot 508 key programming cars come with a remote-start feature that allows the driver to start the car from afar and then warm up or cool down the vehicle prior to entering. This feature is extremely beneficial, especially in the cold winter months. Remote start systems can not function due to a variety of reasons, including an inactive coin-battery.

The coin-shaped battery that is inside the key fob could last between two and four years, based on how often it's used, where it was purchased, and how it is utilized. The use-by date will be printed on the package or in the user's manual.

If the key fob stops working after being exposed to water that is clean, remove the battery and clean the electronic chip using an absorbent paper towel that has been soaked in isopropyl ethanol. Then dry the chip thoroughly before replacing. If the key fob has been exposed to soapy or salty water, it may have fried the chip. You will need to replace it.

If you're not sure the battery is defective, you can test the voltage with a multimeter set to your vehicle's voltage range and connected to the minus and plus terminals. The voltage should be between 12-13 volts, however, if it reads lower, the battery must be replaced. You can also reset your onboard computer by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should now begin.

Faulty Receiver Module

If you don't see "Key Detected" message, it could mean the receiver module not working properly. It's the component that sends out an alert when your key fob is activated. It also acts as an alarm, and stops the car from starting if it doesn't have the correct key.

This could be due to a range of reasons, including water damage or simply aging. If your Peugeot 308 key fob was exposed to dirty tap water, as in the chip that is located on the inside will be damaged. In this case you will have to remove it and thoroughly clean it using isopropyl or electronic cleaner. Once it's dry, you can put the battery back in and try again.

If the issue persists you're probably in need of a idea to seek out a local Peugeot specialist or locksmith. They'll be able to employ a diagnostic tool assist in identifying the problem and fix it.

It is stressful to lose your Peugeot car key. A certified auto locksmith will be able to resolve the issue within minutes. They can cut a brand new key and programme it to your vehicle, so you're back on the road again in the shortest time possible. Click here to locate a locksmith in your area.

Faulty Electronic Chip

The electronic chip in the Peugeot 308 key fob plays an essential part in the remote control system. If it gets damaged, your car might not start or you may receive a message saying "anti-theft active". If this occurs, the only solution to fix the issue is to obtain a new key. Auto locksmiths who are professionals are able to provide the fastest possible time.

The chip inside your peugeot 208 key programming 308 key fob can be damaged due to water damage, sweat dirt, or other reasons. If your Peugeot 308 key fob is exposed to soapy water, you must clean it immediately. You can make use of a paper towel and isopropyl alcohol to wipe the electronic component. Then, you need to let the battery dry completely.

Sometimes keys can stop working because of radio interference. This could be caused by other devices that operate at the same frequency as your Peugeot key fob. It can also be caused by bad weather or objects in the vicinity. It is recommended that you visit a peugeot 307 key fob replacement dealer in the event of this problem.

The Peugeot Key Fob 207/308 is very delicate and requires particular care. You shouldn't drop it or throw it around. If you lose something, try to locate it as quickly as you can. You can reset all the on-board computers by disconnecting the 12 volt battery for a short period of time. Make sure you disconnect the negative cable first, then the positive.